What is TBT? #
The Total Blocking Time (TBT) metric measures the total amount of time between First Contentful Paint (FCP) and Time to Interactive (TTI) where the main thread was blocked for long enough to prevent input responsiveness.
The main thread is considered "blocked" any time there's a Long Task—a task that runs on the main thread for more than 50 milliseconds (ms). We say the main thread is "blocked" because the browser cannot interrupt a task that's in progress. So in the event that a user does interact with the page in the middle of a long task, the browser must wait for the task to finish before it can respond.
If the task is long enough (e.g. anything above 50 ms), it's likely that the user will notice the delay and perceive the page as sluggish or janky.
The blocking time of a given long task is its duration in excess of 50 ms. And the total blocking time for a page is the sum of the blocking time for each long task that occurs between FCP and TTI.
For example, consider the following diagram of the browser's main thread during page load:
The above timeline has five tasks, three of which are Long Tasks because their duration exceeds 50 ms. The next diagram shows the blocking time for each of the long tasks:
So while the total time spent running tasks on the main thread is 560 ms, only 345 ms of that time is considered blocking time.
|Task duration||Task blocking time|
|Task one||250 ms||200 ms|
|Task two||90 ms||40 ms|
|Task three||35 ms||0 ms|
|Task four||30 ms||0 ms|
|Task five||155 ms||105 ms|
|Total Blocking Time||345 ms|
How does TBT relate to TTI? #
TBT is a great companion metric for TTI because it helps quantify the severity of how non-interactive a page is prior it to becoming reliably interactive.
TTI considers a page "reliably interactive" if the main thread has been free of long tasks for at least five seconds. This means that three, 51 ms tasks spread out over 10 seconds can push back TTI just as far as a single 10-second long task—but those two scenarios would feel very different to a user trying to interact with the page.
In the first case, three, 51 ms tasks would have a TBT of 3 ms. Whereas a single, 10-second long tasks would have a TBT of 9950 ms. The larger TBT value in the second case quantifies the worse experience.
How to measure TBT #
Lab tools #
What is a good TBT score? #
To provide a good user experience, sites should strive to have a Total Blocking Time of less than 200 milliseconds when tested on average mobile hardware.
For details on how your page's TBT affects your Lighthouse performance score, see How Lighthouse determines your TBT score
How to improve TBT #
To learn how to improve TBT for a specific site, you can run a Lighthouse performance audit and pay attention to any specific opportunities the audit suggests.
To learn how to improve TBT in general (for any site), refer to the following performance guides:
- Reduce the impact of third-party code
- Minimize main thread work
- Keep request counts low and transfer sizes small